Williamson's 3D Drafting, LLC - Company Message
About Us

Our company has been in business since January 2007. We are 100% owned & operated by a US Army veteran. We have been doing 3D design since 2001. We started off using AutoCad (AC), then we transitioned into Solidworks (SW) in 2003. We found that AC was very difficult to design in 3D. Designing nearly anything in SW can be done as long as a procedure is followed. If there is no procedure to follow, time can be spent trying to figure out the best avenue. We use SW2014 to design all of our customers parts. We also use a FARO arm (CMM) to reverse engineer many parts that need to have exact numbers that a set of calipers won't do. (The parts cannot be larger than 6ft.)

Our goal is to add our own FARO arm with scanning technology to further assist our customers in designing the perfect part, we hope to add this to our company in the next year or so. Scanning can be done to a part that may have a print but is hardly readable or is just old. 

Our company is based on the belief that our customers' needs are of the utmost importance. Our entire team is committed to meeting those needs. As a result, a high percentage of our business is from repeat customers and referrals.

We would welcome the opportunity to earn your trust and deliver you the best service in the industry.

Location:
3008 Chestnut Street
Cuba, MO 65453

Hours:
Mon - Fri: Call for Appointment
Sat: Call for Appointment
Sun: Call for Appointment


Website Builder provided by  Vistaprint
MapQuest Terms and Conditions Maps/Directions are informational only. User assumes all risk of use. MapQuest, Vistaprint, and their suppliers make no representations or warranties about content, road conditions, route usability, or speed.